Differences

This shows you the differences between two versions of the page.

--- electrical [2026/07/05 18:38] – jmct
+++ electrical [2026/07/06 21:30] (current) – jmct
@@ Line 1: / Line 1: @@
+====== Power Flow Diagram ======
+The high level view of how power is stored/distributed is in the diagram below.
+{{ :camp-electrical-flow.png?1000 |}}
+In the following sections we'll have more details about each of the constituent parts.
 The electrical system is mainly solar powered and stored in an array of batteries.
@@ Line 16: / Line 26: @@
 Because there are two arrays of solar panels, Ken made the good decision to use two separate charger controllers. Each one is a {{ :10-001-1_rev_u_classic_manual_19jan2022.pdf |MidNite Classic}} (I am pretty sure, that they are Classic 250. I am unsure if they are the SL (solar only) or the 'normal' ones.
+===== Different output of charge controllers  =====
+It is common to see one of the output controllers doing a lot more work that the other. Here's an example from a particularly sunny day:
+{{ :charge-controller-side-by-side.jpeg?600 |}}
+While their input is relatively similar (66.3V vs. 63.7V, respectively), their _output_ is very different: 0 Watts/0.3kWh vs. 401 Watts/6.9kWh, respectively (it's a happy coincidence that the lower input controller is actually providing more output because the input, as long as it is above the 27V threshold, is irrelevant for the differing output.
+The output differs because the controllers 'back off' when the charge of the batteries is near their capacity. In this case, the controller on the right is observing a slightly lower voltage and is using the power from its panels to charge and/or hold the batteries at that voltage. The other controller sees that the batteries are at or above their voltage threshold and determines that there is no work to do.
+This is expected behavior mid day when the batteries are nearly fully charged.
+==== Sanity Test ====
+In the morning when there is sun but the batteries have been drained over night, we should see both controllers providing output. The following is a photo from a morning charge on an overcast day:
+{{ :wiki:midnite-controller-charging.jpeg?600 |}}
+===== State of Charge =====
@@ Line 29: / Line 60: @@
 The MidNite controllers and the battery bank are connect to a {{ :dcdisconnectuserguide-42813.pdf | Trace Engineering DC Disconnect}}.
+====== Battery Health Checking ======
+[[batterylist|batterylist]]